Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Highlighted
Community Member

Cisco ASA 5550 static NAT problem

Hello,

I have 1 problem in configuration which normally worked on PIX 6.3(1) but showing Warning message during implementation on ASA.

I have 2 statics:

static (dmz,outside) tcp XXX.XXX.XXX.XXX 8080 YYY.YYY.YYY.YYY 8080 netmask 255.255.255.255 0 0

static (inside,outside) tcp XXX.XXX.XXX.XXX https ZZZ.ZZZ.ZZZ.ZZZ https netmask 255.255.255.255 0 0

Public ip XXX.XXX.XXX.XXX is the same, private ips in inside and dmz is different

The second static ASA not allowing me to enter: Warning: conflict with previous static

On Pix 515 v.6.3(1) this configuration worked very well.

Is there any trick to start this work??

Thanks. Alex

2 REPLIES
Green

Re: Cisco ASA 5550 static NAT problem

Do you have another static with ZZZ.ZZZ.ZZZ.ZZZ?

Community Member

Re: Cisco ASA 5550 static NAT problem

ZZZ.ZZZ.ZZZ.ZZZZ is internal ip, there is no any other static configured for it.

Error showing problem of XXX.XXX.XXX.XXX IP address conflict

377
Views
0
Helpful
2
Replies
CreatePlease to create content