Hi guys, I own a pair of Cisco ASA 5510 running version 8.x of PIX-OS in an Active/Passive failover setup, configured as router on a stick with redundant interfaces. â¨â¨shield1(config)# sh int outside â¨Interface Redundant1.100 "outside", is up, line protocol is up â¨... â¨â¨I would like to meter incoming and outgoing traffic on all VLANs but I was unable to locate the correct SNMP OID to poll. â¨â¨Anyone know if this is supported? â¨â¨Thanx a lot in advance for you help. â¨â¨Best, â¨â¨Emanuele
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...