Hi all, when configuring the acl's on my asa using the asdm, how do I know if the access list is in or out ? does the firewall automatially know this when you add the source and destination networks? as in the cli you normally put the keyword in or out, and its a little bit confusing using the asdm, can anyone confirm how we check if its incoming or outgoing ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...