Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco ASA bootproblem

Whenever my ASA boots, it needs more then one attempt to load the IOS. It starts doing it over and over again (mostly 4 or 5 times) At the end, it succeeds and I have a prompt. Doing some research, this does not look oke is it?

ciscoasa# sh boot

BOOT variable =
Current BOOT variable =
CONFIG_FILE variable =
Current CONFIG_FILE variable =

Some add information:

ciscoasa# sh ver

Cisco Adaptive Security Appliance Software Version 8.4(4)
Device Manager Version 6.4(9)

Compiled on Mon 21-May-12 10:48 by builders
System image file is "disk0:/asa844-k8.bin"
Config file at boot was "startup-config"

ciscoasa up 24 mins 13 secs

Hardware:   ASA5505, 256 MB RAM, CPU Geode 500 MHz
Internal ATA Compact Flash, 128MB
BIOS Flash M50FW080 @ 0xfff00000, 1024KB

Encryption hardware device : Cisco ASA-5505 on-board accelerator (revision 0x0)
                             Boot microcode   : CN1000-MC-BOOT-2.00
                             SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03
                             IPSec microcode  : CNlite-MC-IPSECm-MAIN-2.06
                             Number of accelerators: 1

0: Int: Internal-Data0/0    : address is 0022.552a.ae03, irq 11
1: Ext: Ethernet0/0         : address is 0022.552a.adfb, irq 255
2: Ext: Ethernet0/1         : address is 0022.552a.adfc, irq 255
3: Ext: Ethernet0/2         : address is 0022.552a.adfd, irq 255
4: Ext: Ethernet0/3         : address is 0022.552a.adfe, irq 255
5: Ext: Ethernet0/4         : address is 0022.552a.adff, irq 255
6: Ext: Ethernet0/5         : address is 0022.552a.ae00, irq 255
7: Ext: Ethernet0/6         : address is 0022.552a.ae01, irq 255
8: Ext: Ethernet0/7         : address is 0022.552a.ae02, irq 255
9: Int: Internal-Data0/1    : address is 0000.0003.0002, irq 255
10: Int: Not used            : irq 255
11: Int: Not used            : irq 255
The Running Activation Key is not valid, using default settings:

Licensed features for this platform:
Maximum Physical Interfaces       : 8              perpetual
VLANs                             : 3              DMZ Restricted
Dual ISPs                         : Disabled       perpetual
VLAN Trunk Ports                  : 0              perpetual
Inside Hosts                      : 10             perpetual
Failover                          : Disabled       perpetual
VPN-DES                           : Enabled        perpetual
VPN-3DES-AES                      : Disabled       perpetual
AnyConnect Premium Peers          : 2              perpetual
AnyConnect Essentials             : Disabled       perpetual
Other VPN Peers                   : 10             perpetual
Total VPN Peers                   : 12             perpetual
Shared License                    : Disabled       perpetual
AnyConnect for Mobile             : Disabled       perpetual
AnyConnect for Cisco VPN Phone    : Disabled       perpetual
Advanced Endpoint Assessment      : Disabled       perpetual
UC Phone Proxy Sessions           : 2              perpetual
Total UC Proxy Sessions           : 2              perpetual
Botnet Traffic Filter             : Disabled       perpetual
Intercompany Media Engine         : Disabled       perpetual

This platform has a Base license.


Running Permanent Activation Key: 0x00000000 0x00000000 0x00000000 0x00000000 0x00000000
Configuration register is 0x1
Configuration last modified by enable_15 at 13:01:05.779 UTC Sun Jul 22 2012

ciscoasa# sh run

ASA Version 8.4(4)
!
hostname ciscoasa
enable password Nd encrypted
passwd encrypted
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 192.168.1.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address dhcp setroute
!
ftp mode passive
object network obj_any
subnet 0.0.0.0 0.0.0.0
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
!
object network obj_any
nat (inside,outside) dynamic interface
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
http server enable
http 192.168.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
client-update enable
telnet timeout 5
ssh timeout 5
ssh key-exchange group dh-group1-sha1
console timeout 0

dhcpd auto_config outside
!
dhcpd address 192.168.1.5-192.168.1.36 inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
  message-length maximum client auto
  message-length maximum 512
policy-map global_policy
class inspection_default
  inspect dns preset_dns_map
  inspect ftp
  inspect h323 h225
  inspect h323 ras
  inspect rsh
  inspect rtsp
  inspect esmtp
  inspect sqlnet
  inspect skinny
  inspect sunrpc
  inspect xdmcp
  inspect sip
  inspect netbios
  inspect tftp
  inspect ip-options
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
Cryptochecksum:7607625bb72b86ef5e8aa2d2bf8b26a1

Everyone's tags (2)
1 REPLY
Hall of Fame Super Gold

Cisco ASA bootproblem

Duplicate posts. 

603
Views
0
Helpful
1
Replies
CreatePlease to create content