Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco ASA interface - optimal throughput

Hi,

See below output:

sh int eth0/1.20

Interface Ethernet0/1.20 "video", is up, line protocol is up

# Attention: This interface is located in a PCI-e x0 slot. For #

# optimal throughput, install the interface in a PCI-e x16 slot #

# if one is available. Refer to 'show controller slot'.        #

  Hardware is i82546GB rev03, BW 1000 Mbps, DLY 10 usec

        VLAN identifier 20

        MAC address c89c.1d16.d92f, MTU 1500

        IP address 10.44.20.253, subnet mask 255.255.255.0

  Traffic Statistics for "video":

        7910 packets input, 6066909 bytes

        6362 packets output, 2359002 bytes

        0 packets dropped

Hardware:   ASA5510, 1024 MB RAM, CPU Pentium 4 Celeron 1600 MHz

Cisco Adaptive Security Appliance Software Version 8.2(5)

This is from a Cisco ASA 5510 which is a fixed configuration firewall, i.e the network ports are in a fixed configuration and not modular. Any idea why this is displayed in the output from the "show interfaces", and can it be safely disregarded?

Regards,

Jacob

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Cisco ASA interface - optimal throughput

Hi Jacob,

This is a cosmetic bug:

CSCtn38474 - Interface warning on ASA - install the interface in a PCI-e x"nn" slot

The bug is fixed but isn't available in any release yet. It can be safely disregarded until a fixed release is ready.

Hope that helps.

-Mike

2 REPLIES
Cisco Employee

Cisco ASA interface - optimal throughput

Hi Jacob,

This is a cosmetic bug:

CSCtn38474 - Interface warning on ASA - install the interface in a PCI-e x"nn" slot

The bug is fixed but isn't available in any release yet. It can be safely disregarded until a fixed release is ready.

Hope that helps.

-Mike

New Member

Cisco ASA interface - optimal throughput

Thanks Mike :-)

1867
Views
0
Helpful
2
Replies