02-11-2014 06:07 AM - edited 03-11-2019 08:44 PM
Hi All,
I have an ASA pair which runs in active/standy configuration and below is my problem:
- The standby ASA reloads every 7days once but at different times not the same time.
- Have replaced the ASA twice.
- Have changed the power point and rack as well.
- There is no crash info file on the flash.
Details of the asa is as below:
Show version:
sh ver
Cisco Adaptive Security Appliance Software Version 8.0(3)
Device Manager Version 6.4(5)106
Compiled on Tue 06-Nov-07 22:59 by builders
System image file is "disk0:/asa803-k8.bin"
Config file at boot was "startup-config"
XXXXX up 1 day 15 hours
failover cluster up 96 days 13 hours
Hardware: ASA5520, 2048 MB RAM, CPU Pentium 4 Celeron 2000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.01
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04
0: Ext: GigabitEthernet0/0 : address is 001d.4524.b166, irq 9
1: Ext: GigabitEthernet0/1 : address is 001d.4524.b167, irq 9
2: Ext: GigabitEthernet0/2 : address is 001d.4524.b168, irq 9
3: Ext: GigabitEthernet0/3 : address is 001d.4524.b169, irq 9
4: Ext: Management0/0 : address is 001d.4524.b165, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 150
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : 750
WebVPN Peers : 2
AnyConnect for Mobile : Disabled
AnyConnect for Linksys phone : Disabled
Advanced Endpoint Assessment : Disabled
This platform has an ASA 5520 VPN Plus license
I am not sure what else I should be looking into and this has been an ongoing issue. Please do shed some light and share you experience on this.
Thanks and Regards,
Kanes.R
02-11-2014 06:58 AM
Hi,
This may be bug (standby reload) with IOS the device currently running. Check Cisco bug toolkit for any known bugs.
Thx
MS
02-11-2014 07:30 AM
Hi Kaneswaran,
Could you provide with the syslog from standby ASA of the time when reload occurs?
- Prateek Verma
02-24-2014 04:44 PM
Hi Guys,
I will have the logs posted soon. Sorry for the delay in response.
Thanks and Regards,
Kanes.R
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide