01-10-2014 11:15 PM - edited 03-11-2019 08:28 PM
Hello
I Done Configuration Transparent mode in Cisco firewall asa 5505. But now we receiving the Email form gmail, yahoomail hotmail , when we try to send the Email get message "your message sent scuccessfully " but it is not reach the destination . server configuration
everything fine i verify the send local emailid reach the local Email id..now how to check firewall block the smtp port outbound..how to allow the smtp port outbound ..
please help me ..
thank you
01-11-2014 04:58 AM
Hello,
If you are going from higher security level to lower security level and there is an ACL on the inside interface in the inbound direction or an outbound ACL on the outside interface make sure you have the
permit tcp any any eq 25
Looking for some Networking Assistance?
Contact me directly at jcarvaja@laguiadelnetworking.com
I will fix your problem ASAP.
Cheers,
Julio Carvajal Segura
http://laguiadelnetworking.com
01-23-2014 04:20 AM
Dear sir
ciscoasa(config)# access-list outside_in extended permit ip any host 10.0.0.10
Error
ciscoasa(config)# permit smtp any any eq 25
^
ERROR: % Invalid input detected at '^' marker.
Thank you
01-23-2014 04:22 AM
Hello,
That of course needs to be set inside of the ACL setup Sr.
Looking for some Networking Assistance?
Contact me directly at jcarvaja@laguiadelnetworking.com
I will fix your problem ASAP.
Cheers,
Julio Carvajal Segura
http://laguiadelnetworking.com
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: