Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco FWSM - Static (Problem)

Hi everyone!

I have a big problem! :(

I have a Cisco already reached the "static" limit as attached image.

In this FWSM have 2 contexts.

I always need create this type of rule when I create any rule have 2 different networks

Example:

To permit the net 192.168.0.0/24 to access net 10.10.10.0/24

access-list dmz extended permit ip 192.168.0.0 255.255.255.0 10.10.10.0 255.255.255 255

static (inside,dmz) 10.10.10.0 10.10.10.0 netmask 255.255.255.0

Thus have many rules "static".

I would like know:

- To not be necessary to use the rule "static" always, I need only enable the "same-security-traffic permit intra-interface" ?

- If this information is correct and I enable this  parameter, I'll have problems with the rules "static" current? 

Thank you!

Everyone's tags (3)
34
Views
0
Helpful
0
Replies