11-07-2012 04:54 AM - edited 03-11-2019 05:20 PM
I have CISCO pix, verion 525,
today while trying to save the config, I am getting below error
GPRS-PIX# wr
Building configuration...
No memory available
Error executing command
[FAILED]
Can you please suggest what can ben the cuase?
and what should do to fix this problem?
Cisco PIX Security Appliance Software Version 8.0(4)
Device Manager Version 6.1(5)51
Compiled on Thu 07-Aug-08 19:42 by builders
System image file is "flash:/pix804.bin"
Config file at boot was "startup-config"
GPRS-PIX up 42 days 7 hours
Hardware: PIX-525, 256 MB RAM, CPU Pentium III 600 MHz
Flash E28F128J3 @ 0xfff00000, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
Encryption hardware device : VAC+ (Crypto5823 revision 0x1)
0: Ext: Ethernet0 : address is 001a.2f35.704e, irq 10
1: Ext: Ethernet1 : address is 001a.2f35.704f, irq 11
2: Ext: Ethernet2 : address is 000f.a3e9.8788, irq 11
3: Ext: Ethernet3 : address is 000f.a3e9.8789, irq 10
4: Ext: Ethernet4 : address is 000f.a3e9.878a, irq 9
5: Ext: Ethernet5 : address is 000f.a3e9.878b, irq 5
6: Ext: GigabitEthernet0 : address is 000e.0cbb.07cb, irq 5
Licensed features for this platform:
Maximum Physical Interfaces : 10
Maximum VLANs : 100
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Cut-through Proxy : Enabled
Guards : Enabled
URL Filtering : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : Unlimited
This platform has an Unrestricted (UR) license.
Serial Number: 810451377
Running Activation Key: 0x713ec564 0x2c463c6b 0x0ca111d4 0xb6602c44 0x04173283
Configuration last modified by enable_15 at 09:55:16.285 GMT/BST Wed Nov 7 2012
GPRS-PIX#
Solved! Go to Solution.
11-08-2012 01:35 PM
Hello,
Great to hear that,
Can you mark it as answered so the ticket gets closed ( as you created you are the only one with the right to do it)
11-07-2012 04:59 AM
some more inputs from the device, if this is useful
GPRS-PIX# show cpu usage
CPU utilization for 5 seconds = 49%; 1 minute: 48%; 5 minutes: 47%
GPRS-PIX#
GPRS-PIX# show block
SIZE MAX LOW CNT
0 400 196 400
4 100 99 99
80 100 30 100
256 2100 2062 2100
1550 8282 6761 7228
2048 100 82 100
2560 164 164 164
4096 100 100 100
8192 100 100 100
16384 106 106 106
65536 16 16 16
GPRS-PIX# show memory
Free memory: 50772144 bytes (17%)
Used memory: 243585952 bytes (83%)
------------- ----------------
Total memory: 294358096 bytes (100%)
11-07-2012 09:38 AM
Hello,
Do the following:
fsck flash
Then try it to do it again,
Regards,
11-08-2012 05:59 AM
restart solved the problem.
pl close it
thanks
11-08-2012 01:35 PM
Hello,
Great to hear that,
Can you mark it as answered so the ticket gets closed ( as you created you are the only one with the right to do it)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide