Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Clear Blocks Command

I am using a Pix 525 6.3(5) and mistakenly had debugging in place for too long, while troubleshooting some issues. Doing a show blocks, shows the 256 block filled to capacity ,therefore it is not logging correctly, nor can I change the queue setting. Will a clear blocks correct the capacity issue? Also, how does this affect the firewall? Can it be done in a production environment?

Thanks

Ryan

1 REPLY
New Member

Re: Clear Blocks Command

I believe "clear blocks" will only clear the counters. Have you tried turning logging off and back on again?

95
Views
0
Helpful
1
Replies