Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLI access list not displayed in ASDM

On our PIX515E that runs PIX 7.2(2) and ASDM 5.2(2), if I enter an access list from the CLI it is not displayed in the ASDM. However the access list works and is displayed when sending the command 'show run'. This is the case for all the acces lists that I have entered via the command line, an example being:

access-list EXTERNAL_access_in extended permit ip BOX1 255.255.255.0 *.*.*.* 255.255.255.0

Obviously, in the real acl the * is an actual IP address.

Any ideas on why this happens are appreciated.

Thanks.

1 REPLY
Bronze

Re: CLI access list not displayed in ASDM

ASDM only show access-lists applied to interfaces. If the access lists aren't applied with an 'access-group' statement, you won't see them in ASDM.

--Jason

Please rate this message if it helped solve some or all of your question/issue.

297
Views
4
Helpful
1
Replies
CreatePlease login to create content