Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clock on pix515e

Hello,

j have a pix 515e Version 6.1, after a current interruption I cannot set the clock of the pix, the command j have used is :

clock set 21:0:0 apr 1 2000

clock set 21:00:00 apr 01 2000

clock set 21:0:0 1 apr 2000

clock set 21:00:00 01 apr 2000

the configuration is remained correct, but without the correct clock I do not acces to the web configuration

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Clock on pix515e

that's awkward.did u put in the commands in configuration mode .I guess u did n't.

you should be in the configuration mode to run these commands:

pix(config)#clock....

4 REPLIES
Cisco Employee

Re: Clock on pix515e

Set the PIX Firewall clock for use with the PIX Firewall Syslog Server and the Public Key Infrastructure (PKI) protocol. (Configuration mode.)

clock

clock set hh:mm:ss month day year

clock set hh:mm:ss day month year

show clock

hh:mm:ss

The current hour:minutes:seconds expressed in 24-hour time; for example, 20:54:00 for 8:54 pm. Zeros can be entered as a single digit; for example, 21:0:0.

month

The current month expressed as the first three characters of the month; for example, apr for April.

day

The current day of the month; for example, 1.

year

The current year expressed as four digits; for example, 2000.

You can interchange the settings for the day and the month; for example, clock set 21:0:0 1 apr 2000.

A time prior to January 1, 1998 or after December 31, 2097 will not be accepted (the maximum date that the clock command can work to).

While the PIX Firewall clock is year 2000 compliant, it does not adjust itself for daylight savings time changes; however, it does know about leap years.

The PIX Firewall clock setting is retained in memory when the power is off by a battery on the PIX Firewall unit's motherboard. Should this battery fail, contact Cisco TAC for a replacement PIX Firewall unit.

New Member

Re: Clock on pix515e

Thanks for the answer, but I had already used this command but pix do not accept and answers: 'Type help or ?? for to list of available commands'. I would want to know if there is something of alternative to this procedure

Cisco Employee

Re: Clock on pix515e

that's awkward.did u put in the commands in configuration mode .I guess u did n't.

you should be in the configuration mode to run these commands:

pix(config)#clock....

New Member

Re: Clock on pix515e

Great!! now works, excuse me for the

stupidity of the question but I did not succeed to resolve, many thanks

Marco

343
Views
0
Helpful
4
Replies