10-06-2014 08:05 AM - edited 03-11-2019 09:52 PM
Hi all,
On a Cisco ASA5510, Version 8.2(1) with ADSM v. 6.2(1) we have this threat detection setting because we'd like like to allow all traffic through at this time:
Would it be correct to assume that this setting will not block any traffic that may normally be considered a threat? We assume the 'Enable Scanning' setting checked by itself just scans the traffic but takes no action.
Solved! Go to Solution.
10-07-2014 12:26 AM
Yes you are correct. It will not block any IP's until you have the "shun" keyword.
Thanks and Regards,
Vibhor Amrodia
10-07-2014 12:26 AM
Yes you are correct. It will not block any IP's until you have the "shun" keyword.
Thanks and Regards,
Vibhor Amrodia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: