Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Completely disabling Cisco ASA threat detection

Hi all,

On a Cisco ASA5510, Version 8.2(1) with ADSM v. 6.2(1) we have this threat detection setting because we'd like like to allow all traffic through at this time:

 

Would it be correct to assume that this setting will not block any traffic that may normally be considered a threat? We assume the 'Enable Scanning' setting checked by itself just scans the traffic but takes no action.

 

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Yes you are correct. It will

Yes you are correct. It will not block any IP's until you have the "shun" keyword.

Thanks and Regards,

Vibhor Amrodia

1 REPLY
Cisco Employee

Yes you are correct. It will

Yes you are correct. It will not block any IP's until you have the "shun" keyword.

Thanks and Regards,

Vibhor Amrodia

269
Views
0
Helpful
1
Replies
CreatePlease to create content