Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Conduit to ACL conversion

Hello,

My Company has a Pix 515E (ver6.3(4)which is currently using conduits I have been ask to convert them to ACL as part of a project. I want to know if there are any pitfalls I should be aware of. I intend to copy the configuration into a notepad and convert using OCC and then paste new config with ACL back to the firewall. There are loads of this conduits on the firewall.

Regards

Pet

1 REPLY
Community Member

Re: Conduit to ACL conversion

Years ago there was a fairly useful tool that you ran your config against. It cleared up 95% of the configuration.

Try this link

http://www.cisco.com/en/US/products/sw/cscowork/ps3992/products_user_guide_chapter09186a008014b1e5.html#wp998787

138
Views
0
Helpful
1
Replies
CreatePlease to create content