12-10-2013 11:20 AM - edited 03-11-2019 08:15 PM
I'm in the process of migrating from an ASA 5520 to an ASA 5525-x with IPS. What is the easiest way of moving the configuration to the new boxes? I have 2 that are set up as an Active/Standby pair. I've read something about just copying the config and applying that to the new box, but want to get some input on that method.
This is going to be a swap out of current hardware for the new so IP addresses and DSN names will not be a problem. They are new 5525X's right out of the box.
Also, 5520 is at 8.4(4)1.
Thanks for the help.
12-10-2013 12:10 PM
I have used the backup/restore method, also the copy config from tftp with sucess.
But of course this depends on the configuration you are exporting. Also i would assume the Cisco X device is running 9.x firmwarw ?
Sent from Cisco Technical Support iPhone App
12-10-2013 12:16 PM
Hello Gary,
At this point where you have both ASAs on an image that is higher than the 8.3 you will be fine with the copy paste buddy.
As Jon said you could use the backup/restore or you could copy and paste the configuration. Whatever fits you the best.
Remember to manually copy the PSK for the VPN with the more system:running-config
Rate all of the helpful posts!!!
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: