I have 2 public ip range from isp. 1range is 188.8.131.52/30(eg) where 1 ip address is used on the isp end while the other is configured on my pix.
The other ip range is 184.108.40.206/28(eg) which is a bigger ip range which i can use for my publicly accessible servers. Is it possible to configure 2 public ip range on pix? Hence should it be configured as below.
External interface: 220.127.116.11
default gw: 18.104.22.168
For NAT of my publicly accessible servers i just use the public ip range 22.214.171.124.
Will the internet be able to access my public servers even though no interface on my pix is assigned with the 2.2.2.x ip?
Re: configure 2 public ip range for my cisco pix 515
Thk you for your reply. I believe the ISP would do the necessary dynamic routing. Hence i can apply my accesslist which permit and deny traffic for my public accessible ip 2.2.2.x to my ext int even though my ext int is configured with 1.1.1.x?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...