configure telnet in FWSM

[mylove142]

Hi all, I use Catalyst 6513 + FWSM. Now, I want to configure how I can telnet to FWSM.

When I connect to Catalyst6513, I use command "session slot 1 process 1" to connect to FWSM. Now I want I can telnet to FWSM, please guide me steps to configure?

If you have any question, please ask me.

Thank you very much,

Regards,

[vitripat]

Here is a link which explains how to configure FWSM for telnet access. This is based on 3.1 code-

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_3_1/fwsm_cfg/mgacc_f.htm#wp1054101

Hope this helps.

Regards,

Vibhor.

[ggozzi]

I suggest you these steps:

Define firewall vlan in the switch

Configure the interface vlan in FWSM

In the FWSM digit:

username xxxx password yyyyy

aaa authentication console telnet LOCAL

telnet ip add netmask interface name

example: telnet 10.10.10.0 255.255.255.0 inside

But I think is better that you configure ssh