Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure telnet in FWSM

Hi all, I use Catalyst 6513 + FWSM. Now, I want to configure how I can telnet to FWSM.

When I connect to Catalyst6513, I use command "session slot 1 process 1" to connect to FWSM. Now I want I can telnet to FWSM, please guide me steps to configure?

If you have any question, please ask me.

Thank you very much,

Regards,

2 REPLIES
Silver

Re: configure telnet in FWSM

Here is a link which explains how to configure FWSM for telnet access. This is based on 3.1 code-

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_3_1/fwsm_cfg/mgacc_f.htm#wp1054101

Hope this helps.

Regards,

Vibhor.

New Member

Re: configure telnet in FWSM

I suggest you these steps:

Define firewall vlan in the switch

Configure the interface vlan in FWSM

In the FWSM digit:

username xxxx password yyyyy

aaa authentication console telnet LOCAL

telnet ip add netmask interface name

example: telnet 10.10.10.0 255.255.255.0 inside

But I think is better that you configure ssh

162
Views
0
Helpful
2
Replies