I've been trying configuring WCCP on my ASA as it didn't work I'm going to try configuring it on my Cisco 6500. I attached my network topology.
I'm not sure in which interface I should apply the WCCP, so just to avoid causing problems on the network I attached what I think it should be done. I would be very grateful if someone could check is that right.
I'm going to check how it works for only a PC (192.168.72.10). The IP 10.250.2.33 is the one configured on the Mcafee Web Gateway. Could be the wccp configuration be applied on the interfaz vlan 154? I think all my web traffic, no matter how is the source, go that way.
access-list 1 permit host 10.250.2.33 access-list 102 permit ip host 192.168.72.10 any
ip wccp version 2 ip wccp 51 redirect-list 102 group-list 1 password aspirina
Thanks for such a quick answer. I would try your suggestion. I'm really concerned about causing any disruption to the network. Do you think is it safe to apply that configuration? I mean, it only applies to web traffic being sent by the PC 192.168.72.12, isn't it? The rest of traffic going through vlan 154, is not affected. I'm worried because vlan 154 is like the link between Cisco 6500 and the FWSM module. It is not a physical interface so I wouldn't like to interrupt the traffic network.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :