Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connecting to ASA5510 with GUI

i have a asa 5510 band new i ve been trying to get configure it with HTTPS with a web browser and nothing is showing just the same page cannot be displayed ive got the ip address configure properly, i can not understand what the problem is. please someone out there help. i have got to have this box up and running by weekend. thank you

6 REPLIES

Re: connecting to ASA5510 with GUI

Hi Eric,

first make sure you have ip connectivity to inside interface ip of fiirewall, if pinagle from your PC go to next check bellow.

make sure your fw is allowing management access for your PC IP address or subnet.

e.i

asa(config)#http mask

for allowing a subnet access say 10.20.20.0/24 on interface called inside

asa(config)#http 10.20.20.0 255.255.255.0 inside

or by just ip source say 10.20.20.2 is your PC

asa(config)#http 10.20.20.2 255.255.255.255 inside

same format applies for telnet and ssh

telnet 10.20.20.0 255.255.255.0 inside

etc..

also make sure http server is enabled

e.i

asa(config)#http server enable

regards

New Member

Re: connecting to ASA5510 with GUI

hello

i just tried configuring the ASA with the

ip http ip add subnet inside command the ASA has an ip add of 1 while my pc has an ip of 150 of the same subnet i cant seem to be able to connect to the ASA with the web browser. am now trying to use command line. help !!!!!

Re: connecting to ASA5510 with GUI

Pls use cli to setup initial management connectivity, can you confirm you can ping the inside interface ip of fw from 150.

Use the example script I provided through cli.

let us know if still problems to help u, also if you could post the output of show version to make sure you have asdm image installed in fw.

Regards

New Member

Re: connecting to ASA5510 with GUI

Please post config.

New Member

Re: connecting to ASA5510 with GUI

hi

what do u mean that post the config

New Member

Re: connecting to ASA5510 with GUI

Log into the ASA via telnet, ssh, or console and issue the command "show run". Copy the entire output and paste here.

3984
Views
0
Helpful
6
Replies