Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

% Connection timed out; remote host not responding

Hello,

We are using 6513 chassis with sup 720. Slost 1 , 2 contains FWSMs and configured as failover .The issue is that when we try to access the primary slot fwsm by

CORE-6513_SW1#session slot 1 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.11 ...
% Connection timed out; remote host not responding

But the secondary in slot 2 is working fine with this cmd as below


CORE-6513_SW1#session slot 2 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.21 ... Open

User Access Verification

Password:

What could be the issue. The current  image is 3.1.

Please update me with the solutions.

swami

1 REPLY
Cisco Employee

Re: % Connection timed out; remote host not responding

It could be a stuck telnet connection counter on the FWSM.

If you can't ssh to it, or telnet, there is not much you can do but reboot the module.

I am pretty sure it will come back fine if you do.

I hope it helps.

PK

7074
Views
0
Helpful
1
Replies
CreatePlease to create content