I have two Pix firewalls in HA mode (Active/Standby). I can connect to the active firewall (F1) but not to the standby firewall (F2). I can ping the firewall F2 and the shaow fail advised that it is there and in standby mode. If i swop the firewalls so that the active becomes the standby using the failover command then i can connect to the new active firewall f2 but i cannot connect to the new standby firewall F1.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...