I have a cisco 2811 router which is connected to 4 routed vlans. I would like to control the bandwidth for the users on these vlan because these vlans are public hotspots. Some users are choking the whole bandwidth due to which others are unable to get connected. I would like to block P2P applications and control the bandwidth there.
How do I go about doing this? I have attached the configuration of my cisco router.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...