I have 2 PIX firewalls that I am removing and replacing with a router (2811) that has 2 FE ports on it. We're trying to merge networks, but still need to route our traffic and do some static NATting. I'm pretty PIX illiterate, but I'll show you the config from the pix and what I'm translating it to on the router.
So, on PIX1 I have NAT statements like (notice the inside,outside).
Dynamic NAT creates active translation entries in a table when a packet crosses from an IP NAT inside interface to an IP NAT outside interface, or vice versa. This dynamic NAT entry can be seen using the show ip nat translation command. Cisco IOS? software checks for any existing active NAT translations in the translations table when either of the following existing dynamic NAT configurations is removed
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...