Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

copying ASA 8.3.1.1 interum image rebbots ASA

Have an ASA 5520 and downloaded 8.3.1.1 Interun release today. When ever I try to

load the image to flash, either using ASDM or tftp, the ASA will reboot

before done writing image to flash. Can download it to ASA just fine, then starts writing to flash, gets to about

3 megs written and the ASA will just reboot. Even did it through the console, no error, just says 'rebooting'. Anyone ever seen this? I have plenty of space on flash, so that is not the issue.

Thx

3 REPLIES
Super Bronze

Re: copying ASA 8.3.1.1 interum image rebbots ASA

Were you upgrading from 8.3.1 to interim 8.3.1.1? or from the previous version of ASA?

To run version 8.3.1, you would need memory upgrade on your ASA 5520, have you also performed the memory upgrade?

Check out this release notes for memory requirement:

http://www.cisco.com/en/US/docs/security/asa/asa83/release/notes/asarn83.html

Also, any specific reason why you upgrade it to an interim release?

New Member

Re: copying ASA 8.3.1.1 interum image rebbots ASA

I have 2Gig ram in ASA and am running 8.3.1 with no issues. Just testing 8.3.1.1 in the lab. It does the reboot when writing image to flash. So copies to memory OK, just gets to about 3 meg writtin to flash and just reboots. Never seem this before.

Super Bronze

Re: copying ASA 8.3.1.1 interum image rebbots ASA

Seems like version 8.3.1(1) has some issue. There is an internal bug, and no workaround at this stage. I would wait for the next interim 8.3.1(2)

593
Views
0
Helpful
3
Replies