Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Crazy NAT and VPN

We have two VPN tunnels one is using site-2-site and the other is using easyvpn. They both terminate on the same interface, and we of course have the same-security-traffic commands entered. We have several VPN's terminating on these interfaces that can communicate fine. The issue is this, one of the tunnels is NAT'ed, so anything going to or from it has to be NAT'ed. It looks like the Firewall does the translations one direction, because we can see hits in the xlate table. however it is not working. Any ideas.

1 REPLY
Bronze

Re: Crazy NAT and VPN

Could you post ur fw config? It might be difficult to analyse

94
Views
0
Helpful
1
Replies
CreatePlease login to create content