Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CRC errors on outside interface

I've noticed a large amt of CRC errors on the outside int of a Pix 515e. We have replaced the cable but the errors are still accumulating; about 48k in the last 24 hours. Bad interface card, do you think?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: CRC errors on outside interface

Check the duplex/speed settings on both side of the connections.

This link might help, could rule out config issues if nothing else...

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface

2 REPLIES
New Member

Re: CRC errors on outside interface

Check the duplex/speed settings on both side of the connections.

This link might help, could rule out config issues if nothing else...

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface

New Member

Re: CRC errors on outside interface

Thanks, that was it. I reset the int to auto. Funny thing is that it can't be done thru PDM if failover is enabled. I had to do it thru cli.

127
Views
0
Helpful
2
Replies