Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Create simple ACL for home network.

I have a home network using a 2600 and PIX515E, and unfortunetly I don't know how to set up ACLs. I read a few Cisco documentation but unfortunetly I am unable to grasp the concept of how to define them. Would anyone be able to give me a crash course on setting up ACLs?

~Nathan

Everyone's tags (5)
3 REPLIES
Silver

Create simple ACL for home network.

Do you have ip addresses and what you want to block from getting from one place to another?

---

Posted by WebUser Adam Sibille from Cisco Support Community App

Community Member

Create simple ACL for home network.

I really want to limit all traffic in. I'm guessing I don't know what an ACL is after all.

Create simple ACL for home network.

Hi Nathan,

ACL is the access control list which will be a rule which you define in your firewall to permit/deny the services based on your protocol/source ip address/destination ip address.

With that you can block the internet/allow only specific to the internet.

But i think in home internet i don think so much you require to block / allow.

Please do rate if the given information helps.

By

Karthik

490
Views
0
Helpful
3
Replies
CreatePlease to create content