10-27-2010 04:09 AM - edited 03-11-2019 12:00 PM
Hi,
Please help on creating Zones on ASA5580 , if anyone could refer some doc on this as i am new to ASA.
regards
Neo
10-27-2010 06:49 AM
Hi Neo,
When you say "zones", what are you referring to or what are you trying to accomplish? Are you looking to setup multiple interfaces/subnets or multiple firewall contexts? Let us know and we can point you toward some documentation that should help.
-Mike
10-28-2010 12:39 AM
Hi,
I want to create different security zones e.g. DMZ etc.
regards
Neo
10-28-2010 04:02 AM
When you refer to "zones" it suggests you might be looking for something similar to the IOS Zone Based Firewall? On the ASA platform the concept is a little different where we utilize security levels among other things to determine the permitted/denied traffic flows.
Perhaps take a look at the example link below and let us know what you are trying to achieve and someone can help you out further.
Thx
Frank
10-28-2010 05:03 AM
Hi Neo,
Thanks for clarifying. What you'll want to do is setup one ASA interface per "zone" that you want to configure. The basic interface parameters you need to configure are:
nameif
ip address
security-level
Here is a guide that will show you some examples and the command syntax needed:
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/intrface.html
If you have any questions about the configuration, feel free to let us know.
Hope that helps.
-Mike
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: