Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CSC-SSM access via CLI

Hi,

Can the CSC-SSM module be configured via CLI. Or only GUI can be used.

Also is there any detailed configuration/Administration guide for CSC-SSM other than the document named "ASA: Send Network Traffic from the ASA to the

CSC-SSM Configuration Example

Document ID: 99141"

3 REPLIES

Re: CSC-SSM access via CLI

There is some cli for troubleshooting and other initial configuration, take a look at (CSC) sections.

http://www.cisco.com/en/US/products/ps6120/products_installation_and_configuration_guides_list.html

New Member

Re: CSC-SSM access via CLI

it can be done via command line but it's menu driven

New Member

Re: CSC-SSM access via CLI

Hi

you can access the module via CLI by entering the command session 1 from the global config mode.

also, the main configuration is done via the GUI, (like which traffic to block etc). However, you will need to create a policy-map using the cli, match it against an ACL and then apply to the interface(depending on how you will using the CSC module) if you want to stop the inside users downloading files apply to the inside interface, or if you want to stop client uploading files via a web app then apply to outside interface.

HTH, please rate if useful.

Regards

Sol

294
Views
7
Helpful
3
Replies
CreatePlease to create content