Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

CSM Deployment Question

Hello,

I have just recently installed Cisco Security Manager 3.1. I have discovered my firewalls. However, in the map view, the CSM does not detect the VPN (site to site) already setup in the firewall config. Also, when deploying a simple access rule, for example, denying a host access to a website, the CSM inserts extra commands(I preview the command and compare to the running-config) then what is required, so I'm hesitant to push out.Is this normal?

-K

1 REPLY
New Member

Re: CSM Deployment Question

I found my answer to my question. For those, who has a similar question, please click on the following link:

http://www.cisco.com/en/US/docs/security/security_management/cisco_security_manager/security_manager/3.0/troubleshooting/guide/polts.html#wp1044751

115
Views
0
Helpful
1
Replies
CreatePlease to create content