Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DCEF process is running at 75%

Can you advise if there is some way to determine why this particular CEF process on slot 2 is running at 75% while the rest appears to be around 30%?

Cairo#sho ip cef resource

Hardware resource allocation status summary

Green (Normal), Yellow (Caution) Red (Alarm)

Slot HW Resource Name Util Alert

2 E2_Rx_PLU 32 G

2 E2_Rx_TLU 75 Y

4 E3 Rx PLU 25 G

4 E3_Rx_TLU 28 G

5 E3 Rx PLU 25 G

5 E3_Rx_TLU 27 G

6 E3 Rx PLU 25 G

6 E3_Rx_TLU 28 G

9 E3 Rx PLU 25 G

9 E3_Rx_TLU 28 G

11 E3 Rx PLU 25 G

11 E3_Rx_TLU 28 G

I would like to increase the CEF alarm parameters to stop the logs on the router being filled with the CEF resource messages, but I am concerned that this process is running higher than the others.

The device is a GSR with IOS Version 12.0(26)S5a

cisco 12012/PRP (MPC7457) processor (revision 0x00) with 1048576K bytes of memory.

MPC7457 CPU at 1263Mhz, Rev 1.2, 512KB L2, 2048KB L3 Cache

Last reset from sw reset

2 Route Processor Cards

2 Clock Scheduler Cards

3 Switch Fabric Cards

4 OC48 POS controllers (4 POS).

3 Single Port Gigabit Ethernet/IEEE 802.3z controllers (3 GigabitEthernet).

1 Three Port Gigabit Ethernet/IEEE 802.3z controller (3 GigabitEthernet).

1 Four Port Gigabit Ethernet/IEEE 802.3z controller (4 GigabitEthernet).

2 Ethernet/IEEE 802.3 interface(s)

10 GigabitEthernet/IEEE 802.3 interface(s)

4 Packet over SONET network interface(s)

2043K bytes of non-volatile configuration memory.

250880K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

65536K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

Thanks

1 REPLY
Cisco Employee

Re: DCEF process is running at 75%

Hi mayambanzumba,

I think you would have better luck posting this question to a different forum.

Sincerely,

David.

129
Views
0
Helpful
1
Replies
CreatePlease login to create content