Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Destination ip translation on Pix version 6.2.

Traffic is fron Inside to Outside. When users from Inside connect to a host on the Outside with destination IP of 10.244.87.1, the pix should translated to 10.244.86.1. The documentation said you can use static for Lower to Higher security. This scenario is however from Higher to Lower. Can I still use static or do I have to use Nat? Please post the command for either method. Thank you.

1 REPLY
Green

Re: Destination ip translation on Pix version 6.2.

static (outside,inside) 10.244.87.1 10.244.86.1 netmask 255.255.255.255

106
Views
0
Helpful
1
Replies
CreatePlease to create content