Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DHCP through PIX firewall

Hi,

I have a Site A and Site B at different geographical location,which are connected using Routers through leased line.

Now at both the location behind the router I have connected a Cisco PIX 515E firewall,behind the firewall I haveconnected L2 switch in both locations.At Site A all clients are connected to L2 switches,and a DHCP server isassigning a dynamic IP address for all clients,at Site B there are no clients but servers and a DHCP server are connected.

Now at Site A,if the DHCP server is down,how the clients will get the dynamic IP address from teh DHCP server which is at Site B.

Is it possible in this scenario?

Please help me I am in the process of desiging the DR site .

Thanks and Regards,

LAVANHOLY

1 REPLY

Re: DHCP through PIX firewall

Are u running a Tunnel IPsec from both of this pix box ?

If you have then you can configure the pix as dhcp server

!--- Specifies a DHCP address pool and the interface for the client to connect.

dhcpd address 192.168.1.5-192.168.1.7 outside

!--- Specifies the IP address(es) of the DNS and WINS server

!--- that the client uses.

dhcpd dns 192.168.0.1

dhcpd wins 172.0.0.1

!--- Specifies the lease length to be granted to the client.

!--- This lease equals the amount of time (in seconds) the client

!--- can use its allocated IP address before the lease expires.

!--- Enter a value between 0 to 1,048,575. The default value is 3600 seconds.

dhcpd lease 3600

dhcpd ping_timeout 50

dhcpd auto_config outside

!--- Enables the DHCP daemon within the Security Appliance to listen for

!--- DHCP client requests on the enabled interface.

dhcpd enable outside or inside

dhcprelay timeout 60

Check the link:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806c1cd5.shtml#server

205
Views
0
Helpful
1
Replies
CreatePlease login to create content