Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Disable Aggressive Mode on a PIX running 6.3

How can I turn off Aggressive mode on a PIX 501 running 6.3?

This is a security issue for our PCI compliance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Disable Aggressive Mode on a PIX running 6.3

You cannot disable aggressive mode in 6.3 code. PIX would try to initiate the connection first on Main mode and if it fails would try

aggressive mode.

Syed Iftekhar Ahmed

4 REPLIES

Re: Disable Aggressive Mode on a PIX running 6.3

You cannot disable aggressive mode in 6.3 code. PIX would try to initiate the connection first on Main mode and if it fails would try

aggressive mode.

Syed Iftekhar Ahmed

Community Member

Re: Disable Aggressive Mode on a PIX running 6.3

Thank you for this information. I was afraid of that. Again thank you for your reply

John

Community Member

Re: Disable Aggressive Mode on a PIX running 6.3

In what version of the code can the disabling of aggressive mode be done?

Thanks!

Cisco Employee

Re: Disable Aggressive Mode on a PIX running 6.3

Hi,

7.0 and higher.

"isakmp am-disable"

http://www.cisco.com/en/US/docs/security/asa/asa70/command/reference/gl.html

Regards,

Arul

*Pls rate if it helps*

1279
Views
5
Helpful
4
Replies
CreatePlease to create content