I did a configure factory-default on a 5505 and after the reboot it set the asa back to the internal interface 192.168.1.1 and everything else as expected. But why did it stil use the previous password that was set when I when into enable mode? I figure the factory-default would have wiped that out as well?
Also, can someone simply explain the difference between flash and disk0? I'd apreciate it if someone could just simply explain without sending links as this will just make me have more questions.
But, in the wireless sphere, there are two ways to wipe an access point. The second method, "wr erase", will only erase the config but your static IP address remains. You have to use the first method, "wr default-config", and this will erase everything.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...