Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

DMZ switch best practice

I have two redundant ASA5520s and am planning to add a 3350 as the DMZ switch. I am looking for advice on the best way to accomplish this (best practice)

1 REPLY
Bronze

Re: DMZ switch best practice

If you're planning on having that switch only service DMZ servers, then I would put a link between each 5520 and the DMZ switch. I assume that you already have the failover setup configured on the other interfaces. Your hosts on the DMZ will need to point to the primary DMZ address for their default gateway.

385
Views
5
Helpful
1
Replies
CreatePlease to create content