I am running Software Version 8.2(1) , Hardware: ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz Internal ATA Compact Flash, 256MB . I have configured ipsec vpn with 12 profile in active state . But at a particular time not more than 5 users are connected to VPN profile.
Is there any commands which would help to know which features has consumed memory of firewall.
Is it safe if i am planning to configure new zone for my servers and make firewall as gateway for the servers configured in this zones,under this 76% memory utilized scenerio where my cpu utilizatio shows only 4%.
IF i will shutdown the Active firewall of DC and Make standby DR firewall as active . SO when i will power on the Active Firewall of DC will it take the standby state or it will come up with Active state .
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...