Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dot1q trunk between two 2950

hi,

if i have a Pix in center of two 2950 and i have to make a trunk between my two 2950.Whether PIx will pass VTp information.

1 REPLY
Silver

Re: dot1q trunk between two 2950

Right from the version 6.3(4)103 PIX version supports VTP trunking. You will have to configure the logical interfaces on the PIX and the switch port connected should be trunked. http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/bafwcfg.html

154
Views
0
Helpful
1
Replies