Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

double firewall and vpn

I'm preparing to implement a double firewall dmz with a couple of ASAs and while drawing it am getting a little confused on how to allow remote access and tunnels to work using the same ASAs that are being used for the double firewall DMZ configuration. Anyone have any advice or maybe a note outlining the config?

thank you,

Bill

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: double firewall and vpn

Instead of multiple Firewall, you can use ASA with multi-context

You can partition a single security appliance into multiple virtual devices, known as security contexts. Each context is an independent device, with its own security policy, interfaces, and administrators. Multiple contexts are similar to having multiple standalone devices. Many features are supported in multiple context mode, including routing tables, firewall features, IPS, and management.

Refer this doc:

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450b42.html#wp1035807

1 REPLY
Silver

Re: double firewall and vpn

Instead of multiple Firewall, you can use ASA with multi-context

You can partition a single security appliance into multiple virtual devices, known as security contexts. Each context is an independent device, with its own security policy, interfaces, and administrators. Multiple contexts are similar to having multiple standalone devices. Many features are supported in multiple context mode, including routing tables, firewall features, IPS, and management.

Refer this doc:

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450b42.html#wp1035807

376
Views
0
Helpful
1
Replies