Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Drops on ASA 5505 ver 7.2(2)

We have a customer with an ASA 5505, which is dropping packets on the outside interface. The output from the "show interface" indicates Switch ingress policy drops.

show int e0/0

Interface Ethernet0/0 "", is up, line protocol is up

Hardware is 88E6095, BW 100 Mbps

Full-Duplex(Full-duplex), 100 Mbps(100 Mbps)

Available but not configured via nameif

MAC address 001a.e2ef.f201, MTU not set

IP address unassigned

277059685 packets input, 74460445394 bytes, 0 no buffer

Received 44 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 L2 decode drops

17179909933 switch ingress policy drops

23266211 packets output, 7912969026 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collisions, 0 deferred

0 lost carrier, 0 no carrier

0 rate limit drops

0 switch egress policy drops

Has anyone seen this before, as i cannot find any information on the CCO to troubleshoot this issue

4 REPLIES
Green
New Member

Re: Drops on ASA 5505 ver 7.2(2)

I have looked at this, but the nameif command is used on the vlan int & the vlan is up. The ASA is connected to a router, so i can't see tagged traffic hitting the interface?

New Member

Re: Drops on ASA 5505 ver 7.2(2)

Hey Everyone,

I am karim

I am using firewall asa5540 7(2).2 and I can see several and continious packet dropped on all interfaces. My asa's are connected usingauto/auto to switches cisco 2950 also using auto/auto.

Can anyone help?

Thanks

New Member

Re: Drops on ASA 5505 ver 7.2(2)

You should never have two Cisco devices connected and set to auto/auto. Always hard code your important links.

176
Views
0
Helpful
4
Replies