I have 2 ISPs,1st terminated on DLink 502T router using PPPoE, and 2nd terminated on PIX 501 directly and uses VPN. Both ISPs are having static IP. I now wish to scrap the 2nd ISP bcoz of inconsistency, and only use the 1st ISP.
I am trying to do a bridge with 502T and PIX 501. But I get the following error, while i try shifting my PIX from STATIC to PPPoE:
[ERR]ip address outside pppoe
Can not enable PPPoE on the same interface as vpdn.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...