Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Duplicate outside circuit for redundancy on ASA

We have an ASA running ver 8.0(4) and telco is proposing a scheme were two identically configured circuits would be handed to me. They would be active/passive in that both would be live but the second won't pass traffic unless the active circuit fails. How can I configure the ASA to support two connections that are Identically configured. Same VPNs, same address translations, same next hop, etc...

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Duplicate outside circuit for redundancy on ASA

What about a redundant pair?

ASA(config)# interface redundant 1

ASA(config-if)# member-interface gigabitethernet 0/0

ASA(config-if)# member-interface gigabitethernet 0/1

4 REPLIES

Re: Duplicate outside circuit for redundancy on ASA

Green

Re: Duplicate outside circuit for redundancy on ASA

What about a redundant pair?

ASA(config)# interface redundant 1

ASA(config-if)# member-interface gigabitethernet 0/0

ASA(config-if)# member-interface gigabitethernet 0/1

Re: Duplicate outside circuit for redundancy on ASA

v.v.very nice - 5 for you.

New Member

Re: Duplicate outside circuit for redundancy on ASA

Thanks - That was just what I needed

115
Views
5
Helpful
4
Replies
CreatePlease to create content