Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

dynamic ACL's needed

Hi;

I have two aplications that need to be accessed fist to sqlnet port 1521 and then it gives the client a port over 1024.

The thing is that it doesn't work if I try to do this access dinamically because I have a rule that accept >1024 and not only the 1521 port.

It's like the FTP dynamic port, it doesn't work.

How I do it to work in a ASA 5520?

Thanks. Regards

2 REPLIES
Silver

Re: dynamic ACL's needed

Make sure the source and destination ports are correctly applied to the interface in the specific direction.

Community Member

Re: dynamic ACL's needed

All you need to do is open port 1521 and inspect sqlnet.

Please see details for the inspect sqlnet command.

This will make ASA/PIX track the changes in the connection starting at port 1521 and changing to what ever port Oracle DB chooses.

Regards Rafiki-TLK

130
Views
7
Helpful
2
Replies
CreatePlease to create content