Edit banner SSH-2.0-Cisco-1.25

[rgchevezh]

Hello,

Is possible to edit the default message SSH-2.0-Cisco-1.25 ??

That message is the response when ssh is enabled on a cisco device router/switch/

Regards

[Collin Clark · Accepted solution]

When do you see this? When you SSH from a client to the router/switch?

[rgchevezh]

Hello,

When I ssh from a PC (MS-DOS) to the router/switch in order to test if port is opened.

Regards,

[rgchevezh]

Thank you,

[Collin Clark]

Try this please-

config t

banner login ^

This is the login banner

^

Then try and connect again.

[rgchevezh]

Hello,

This message is not the banner login, because banner login is displayed before the username and password login prompts, when i do a telnet x.x.x.x 22 I'm testing if the port is opened..  is a common testing procedure to test any port

:

telnet x.x.x.x 22

telnet x.x.x.x 23

telnet x.x.x.x 443

telnet x.x.x.x 3389 and etcetera....

Regards,

[Collin Clark]

Ahh, I see what you're doing now. AFAIK there is no way of changing that.

[rgchevezh]

Thank you Collin