Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Edit banner SSH-2.0-Cisco-1.25

Hello,

Is possible to edit the default message SSH-2.0-Cisco-1.25 ??

That message is the response when ssh is enabled on a cisco device router/switch/

Regards

1 ACCEPTED SOLUTION

Accepted Solutions

Edit banner SSH-2.0-Cisco-1.25

When do you see this? When you SSH from a client to the router/switch?

7 REPLIES

Edit banner SSH-2.0-Cisco-1.25

When do you see this? When you SSH from a client to the router/switch?

New Member

Edit banner SSH-2.0-Cisco-1.25

Hello,

When I ssh from a PC (MS-DOS) to the router/switch in order to test if port is opened.

Regards,

New Member

Edit banner SSH-2.0-Cisco-1.25

Thank you,

Edit banner SSH-2.0-Cisco-1.25

Try this please-

config t

banner login ^

This is the login banner

^

Then try and connect again.

New Member

Edit banner SSH-2.0-Cisco-1.25

Hello,

This message is not the banner login, because banner login is displayed before the username and password login prompts, when i do a telnet x.x.x.x 22 I'm testing if the port is opened..  is a common testing procedure to test any port

:

telnet x.x.x.x 22

telnet x.x.x.x 23

telnet x.x.x.x 443

telnet x.x.x.x 3389 and etcetera....

Regards,

Edit banner SSH-2.0-Cisco-1.25

Ahh, I see what you're doing now. AFAIK there is no way of changing that.

New Member

Edit banner SSH-2.0-Cisco-1.25

Thank you Collin

271
Views
0
Helpful
7
Replies