Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Editing extended ACE's -FWSM 2.3 on Catalyst 6500

Hello All, I am trying to edit an ACL on a FWSM running version 2.3(3), and need to delete certain lines (ACE's) on an extended ACL.

When I run : show access-list ACL_id,

I do not see the line numbers, therefore I do not know how to remove the ACE's that are not needed.

In version 3.1 there is a way to remove an ACE with a no command. Would this work with FWSM version 2.3 as well, if I just negate a certain ACE?

Thank you in advance.

Dmitry.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Editing extended ACE's -FWSM 2.3 on Catalyst 6500

Hi Dmitry

Yes you should be fine with this. Regardless of whether there is a line number you can just use a "no" in front of the ACE entry and it will just remove that line.

HTH

Jon

2 REPLIES
Hall of Fame Super Blue

Re: Editing extended ACE's -FWSM 2.3 on Catalyst 6500

Hi Dmitry

Yes you should be fine with this. Regardless of whether there is a line number you can just use a "no" in front of the ACE entry and it will just remove that line.

HTH

Jon

New Member

Re: Editing extended ACE's -FWSM 2.3 on Catalyst 6500

Thank you Jon.

217
Views
0
Helpful
2
Replies
CreatePlease to create content