I have an ASA 5520 on which I've enabled EIGRP. There are two routers to which it is a neighbor and these have equal cost distance to a network across the network. The network will automatically load-balance but the default is on a per destination basis. I would like to have it load balance on a per packet basis as we have one large load to the same destination. On the router IOS v12.4 there is a way to change this on a per interface basis (ip load-balance per-packet) but I haven't found the equivalent command in the ASA sw v 8.0(3). Does anyone know if there is such a command or another way to achieve this? Thanks.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...