Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Embryonic Limit Very Well Exceeded

Hi,

I have PIX 501 with 10 Embryonic connections allowed. During some of the SYN attacks, PIX responds to late. Resulting log shows figures like 500/10 which means that it stopped the offending connection after 500 embryonic connections instead of 10. Is there something I can do so that I get 10/10 logs again?

Thanks.

2 REPLIES
New Member

Re: Embryonic Limit Very Well Exceeded

HI,

Try and change the default embryonic conenction timeout .

Raj

New Member

Re: Embryonic Limit Very Well Exceeded

Thanks Raj,

However, I can not find the place to configure that. Which command should I use?

Can

145
Views
0
Helpful
2
Replies
CreatePlease to create content